Introduction to Battlefront
Paints & Decals
Product Assembly Guides
Purchase these Items
Products mentioned in this Article
UBX50 M3 Lee Tank Platoon (Plastic)
Assembling the L6/40 (IBX17)
Assembling the AB41 (IBX16)
Assembling 90mm Lancia (IBX15)
Assembling The Autocannone (IBX20)
Assembling The Falco CR42 (IBX19)
Assembling The Italian 88mm Anti-Tank Battery (IBX13)
Assembling The 100MM Howitzer (IBX12)
Assembling The Semovente (ITAB02)
Assembling the Bersaglieri Assault Engineer Platoon (IT765)
Assembling the Bersaglieri Weapons Platoon (IT762)
Begin assembly of the Lee by attaching the left-hand side tracks to the hull section.
Next, attach the right-hand side tracks to the hull section.
Both tracks in place.
Next, attach the transmission cover and back plate.
Completed lower hull assembly.
Attach the upper hull piece to the lower hull assembly.
Next, fit the hull gun and its housing. Only glue the housing, allowing the gun to rotate freely.
Attach the stowage bins to the rear of the tank.
Stowage bins in place.
Next, glue the two turret pieces together.
Fit the gun to the turret.
Sprue features both open and closed commander hatches.
Attach your choice of commanders hatch.
Fit your commander in the hatch.
Commander in place.
Attach the turrent peg to the underside of the turret.
Turret peg attached.
Mount the turret on the hull assembly.
A fully assembled M3 Lee.
Last Updated On
Wednesday, September 20, 2017
by Chris at Battlefront
Battlefront Miniatures 2006-2017. Website by